D-Link DWC-2000 Quick Installation Manual
D-Link DWC-2000 Quick Installation Manual

D-Link DWC-2000 Quick Installation Manual

Wireless controller
Hide thumbs Also See for DWC-2000:

Advertisement

Quick Installation Guide

Wireless Controller
This document will guide you through the
basic installation process for your
new D-Link Wireless Controller.
DWC-2000
Quick Installation Guide
Documentation is also available on
CD and the D-Link website

Advertisement

Table of Contents
loading

Summary of Contents for D-Link DWC-2000

  • Page 1: Quick Installation Guide

    Quick Installation Guide Wireless Controller This document will guide you through the basic installation process for your new D-Link Wireless Controller. DWC-2000 Quick Installation Guide Documentation is also available on CD and the D-Link website...
  • Page 2: About This Guide

    Fan LED on the wireless controller from those shown in the illustrations. These ports can support The DWC-2000 Wireless Controller is a full- USB ports (1-2) various USB 1.1 or 2.0 featured wireless LAN controller designed for devices medium to large network environments.
  • Page 3: Before You Begin

    Green receiving data at present and undamaged. If any item is missing 100 Mbps. or damaged, please contact your local D-Link Solid Port is operating reseller for a replacement. Orange at 1000 Mbps.
  • Page 4: Step 2 - Installation

    Step 2 – Installation You can mount the DWC-2000 into a stand- ard 19-inch equipment rack. To install the DWC-2000 into a rack: 1. Attach the mounting brackets to each side of the chassis as shown in Figure 5 and secure them with the screws provided.
  • Page 5: Initial Configuration

    The default login information is: The wireless controller software is preinstalled • Username: admin on the DWC-2000. When the device is powered • Password: admin on, it is ready to be configured. It comes with a default factory configuration that allows you to connect to it, but you should configure the con- troller for your specific network requirements.
  • Page 6 2. Connect the Unified AP you want to config- ure to the local area Ethernet network. Figure 13. WLAN Wizard 3. Log into the DWC-2000 and set the LAN IP 2. Below are two methods to add access address to be in the subnet of the local area points in the managed AP list: Ethernet network.
  • Page 7: Additional Information

    DWC-2000. • D-Link Wireless Controller User Manual This manual describes the general opera- tion and control of the wireless controller firmware which drives and controls the wireless controller hardware. It includes Figure 14.
  • Page 8 Ver. 1.00(WW) 2013/12/06...

Table of Contents