Table of Contents
Advertisement
3. INSTALLATION
3.1 HOW TO INSTALL THE UNIT
1. To avoid vibration and noise, make sure the unit is installed securely and
firmly.
2. Install the unit where the sunlight does not shine directly on the unit.
If the unit receives direct sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, like a fence, within 20" which might restrict
heat radiation from the condenser.
4. To prevent reducing performance, install the unit so that louvers of the
cabinet are not blocked.
5. Install the unit a little obliquely outward not to leak the condensed water
into the room (about 1/2" or 1/4" bubble with level).
6. Install the unit with its bottom portion 30~60" above the floor level.
7. Stuff the foam between the top of the unit and the wall to prevent air and
insects from getting into the room.
8. The power cord must be connected to an independent circuit. The green
wire must be grounded.
9. Connect the drain tube to the base pan hole in the rear side if you need
to drain (consult a dealer).
Plastic hose or equivalent may be connected to the drain tube.
3.2. HOW TO DRAIN
(When using drain pipe)
The air conditioner must be installed horizontally or
tilted slightly to the outside for proper water drainage.
On exceptionally hot and humid days the air
conditioner may overflow condensed water.
If the air conditioner is used in a hot and high
humidity zone, exchange the
the
DRAIN PIPE.(See figure 17, figure 18.)
Press the drain pipe into the hole by pushing down
and away from the fins to avoid injury
3.3 HOW TO USE THE REVERSIBLE
INLET GRILLE
The grille is designed to clean the filter both upward and downward.
A. BEFORE ATTACHING THE FRONT GRILLE TO THE CABINET,
IF YOU WANT TO PULL OUT THE FILTER UPWARD;
1. Open the inlet grille slightly (a).
2. Turn inside out the front grille (a).
3. Disassemble the inlet grille from the front grille with
separating the hinged part by inserting a straight type
screw-driver tip (b).
4. Then, rotate the inlet grille 180 degrees and insert the hooks
into bottom holes of the front grille.
5. Insert the filter and attach the front grille to the cabinet.
B. IF YOU WANT TO PULL OUT THE FILTER DOWNWARD;
The grille is already designed for that way.
HOLE RUBBER for
—12—
FOAM
COOLED
AIR
BASE PAN
HOLE RUBBER
1
BASE PAN
DRAIN PIPE
2
(a)
(c)
1/4 Bubble
Level
FENCE
AWNING
HEAT
RADIATION
About 1/2"
Over 20"
BOTTOM
hang
push
BOTTOM
b
(b)
Advertisement
Table of Contents
