Table of Contents
Advertisement
Maintenance
Replacing the Drive Belt
Squealing when the belt is rotating, blades slipping
when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn drive belt. Replace the
drive belt if any of these conditions are evident.
1.
Stop the engine, remove the key and disconnect
the spark plug wire(s) from the spark plug(s).
2.
Remove the hand knobs holding the deck cover
to the top of the cutting unit and remove the
deck cover.
3.
Loosen the jam nuts on each adjusting shaft to
loosen the tension on the drive belt.
1
Figure 24
1. Jam Nuts
4.
Remove the worn drive belt (Fig. 25).
5.
Install the new drive belt onto the traction unit
drive pulley and the top groove of the center
spindle pulley (Fig. 25).
16
2
m–2541
2. Adjusting Shaft
4
Figure 25
1. Belt Guide (2)
2. Traction Unit Drive Pulley
6.
Tighten the jam nuts on the adjusting shafts until
the springs are compressed to a length of 5"
(12.7 cm) (Fig 26).
2
1
Figure 26
1. 5" between the Spacer
and Bushing
7.
Reinstall the deck cover onto the cutting unit,
then reinstall and tighten the hand knobs.
2
1
3
3. Drive Belt
4. Center Spindle Pulley
m–2541
2. Jam Nuts
Advertisement
Table of Contents
