Table of Contents
Advertisement
Operation
Adjusting the Height-of-Cut
The height-of-cut is adjustable from 2" to 5" (51 to
127 mm) in 1/2-inch (13 mm) increments by
relocating the clevis pins in different hole locations in
brackets at each corner of the cutting unit (Fig. 9).
Stop the engine before adjusting the height-of-cut.
Note:
All four pins must be in the same hole
location for even cutting.
1
2
3
4
5
6
7
9
Figure 9
1. 2" (51 mm) Cut Height
2. 2-1/2" (64 mm) Cut Height
3. 3" (76 mm) Cut Height
4. 3-1/2" (89 mm) Cut Height
5. 4" (102 mm) Cut Height
8
8
6. 4-1/2" (114 mm) Cut
Height
7. 5" (127 mm) Cut Height
8. Clevis Pin
9. Hairpin Cotter
Adjusting Gage Wheels
The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1.
After adjusting height-of-cut. raise the
attachment lift lever: Refer to Raising
Attachments.
2.
Remove hairpin cotter and pin to change hole
location (Fig. 10).
3.
Select a hole position so the gage wheel is 3/8"
(9.5 mm) off the ground for the height-of-cut to
be used (Fig. 10).
4.
Insert pin and secure with hairpin cotter.
5.
Repeat adjustment on other gage wheels.
3
1
Figure 10
1. Wheel
2. Pin
2
m–3197
3. Hair pin Cotter
Advertisement
Table of Contents
