Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING
Self-diagnosis Function
This product has a built-in self-diagnosis function. If an error occurs, the lamp of the indoor unit will blink in 2
second intervals. If this occurs, contact your local dealer or service center.
Before Calling for Service
Please check the following before you contact the service center. If the problem persists, contact your local
service center.
Problem
The air conditioner
does not work
normally.
The air conditioner
does not work.
Possible Causes & Corrective Action
Burning smell and strange sounds are coming from the unit.
Turn off the air conditioner, switch OFF, or disconnect the power supply, and
contact the service center.
Water leaks from the indoor unit even when the humidity level is low.
Turn off the air conditioner, switch OFF, or disconnect the power supply, and
contact the service center.
The power cable is damaged or it is generating excessive heat.
Turn off the air conditioner, switch OFF, or disconnect the power supply, and
contact the service center.
A switch, a circuit breaker (safety, ground), or a fuse is not operated
properly.
Turn off the air conditioner, switch OFF, or disconnect the power supply, and
contact the service center.
The unit generates an error code from its self-diagnosis.
Turn off the air conditioner, switch OFF, or disconnect the power supply, and
contact the service center.
The air conditioner is unplugged.
Check whether the power cord is plugged into the outlet or the power isolators
are switched on.
A fuse exploded, or the power supply is blocked.
Replace the fuse or check if the circuit breaker has tripped.
A power failure has occurred.
Turn off the air conditioner when a power failure occurs.
When the power is restored, wait 3 minutes, and then turn on the air
conditioner.
The voltage is too high or too low.
Check if the circuit breaker has tripped.
The air conditioner was turned off automatically at a preset time.
Turn the air conditioner on.
The battery setting in the remote controller is incorrect.
Make sure that the batteries are inserted correctly in your remote controller.
If the batteries are placed correctly, but the air conditioner still does not operate,
replace the batteries and try again.
EN
29
Advertisement
Chapters
Table of Contents
