Assembling The Blower; Converting From Blower To Vacuum - Toro 51594 Operator's Manual

Ultra blower/vacuum

Hide thumbs Also See for 51594:

Table of Contents

Available languages

Setup

Assembling the Blower

Parts needed for this procedure:

Install the blower tube and then the inlet cover onto the blower housing.

NOTICE! You must install the blower tube before installing the

inlet cover because the inlet cover hooks onto the blower tube.

The blower will not run unless the bottom inlet cover is locked

in place.

Parts needed for this procedure:

WARNING

The impeller rotates for a few seconds after you turn off the

blower and can cut or injure fingers.

Do not remove the bottom inlet cover when the motor is running

or when the unit is plugged into a power outlet.

Remove the inlet cover and the blower tube from the blower

housing.

Install the vacuum tube onto the blower housing and connect the

lower vacuum tube to the upper tube, securing it with the supplied

fastener.

NOTICE! The vacuum will not run unless the vacuum tube

is locked in place.

Note: You may need to push the connector firmly to ensure that

it seats all the way into the vacuum tube.

Table of Contents