Table of Contents
Advertisement
MULTI V
Indoor Unit
10. Installation
Drill a Hole in the wall
1.Drill the piping hole with a ø 70mm hole core drill.
Drill the piping hole at either the right or the left with
the holes slightly slanted to the outdoor side.
Drain Piping
1.The drain hose should point downward for easy
drain flow
2.Do not make drain piping like the following.
10.3 Wiring the cable to the indoor units
10.3.1 General instructions
•
All field supplied parts and materials, electric works must conform to local codes. Use copper wire only.
•
Follow the "WIRING DIAGRAM" attached to the unit body to wire the outdoor unit, indoor units and the remote
controller.
•
All wiring must be performed by an authorized electrician.
•
A circuit breaker capable of shutting down the power supply to the entire system must be installed.
CAUTION
After the confirmation of the above conditions, prepare the wiring as follows:
Indoor
Do not raise
Water
leakage
Accumulated
drain water
Air
Water
Waving
leakage
* The feature can be changed according to type of model.
Wall Mounted Unit (Standard)
Wall
Outdoor
Downward slope
Tip of drain hose
dipped in water
Water
leakage
Ditch
Less than
50mm gap
51
Hide quick links:
Advertisement
Table of Contents
