Table of Contents
Advertisement
Wiring Diagram
J4
J5
WIRE LIST
DESIG. AWG
COLOR ROUTE
W1
16
WHITE
W2
16
WHITE
W3
16
BLUE
W4
16
BLACK
W5
16
BLACK
Cleaning and Storage
1. Disengage the power take off (PTO) and set the parking
brake.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important
You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, and engine.
3. Check the brake; refer to Servicing the Brakes, page 32.
4. Service the air cleaner; refer to Servicing the Air
Cleaner, page 28.
5. Grease the machine; refer to Greasing and Lubrication,
page 31.
6. Change the crankcase oil; refer to Servicing the Engine
Oil, page 29.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 31.
8. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank.
W1
W3
J2 J4
J2 J3
P1–1 J5
P1–2 J1
J1 P2–1
P2
IGNITION SWITCH
1
W5
W4
1
2
P1
PTO
A. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank, page 33, or operate
engine until it stops.
C. Restart engine and run until it stops. Repeat, on
choke until engine will not restart.
D. Dispose of fuel properly. Recycle as per local codes.
Note: Do not store stabilizer/conditioned gasoline over
90 days.
9. Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plug, page 30. With the spark
plug(s) removed from the engine, pour two tablespoons
of engine oil into the spark plug hole. Now use the
starter to crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage area.
Cover the machine to protect it and keep it clean.
38
2
W2
J2
MAG
J1
GND
Advertisement
Table of Contents
