Table of Contents
Advertisement
NAME OF EACH PART
4
NAME OF EACH PART
9
1
2
3
4
Debugger connector : For bootloader pro-
gram writing and debugging.
Start S/W : On/Off switch for data save.
Dip S/W : The switch for selecting Multi-V
model.
Comm connector : For Setting the Date
and Time.
Main PCB Connector : For Connecting
Main PCB and Data Saving Module.
Status LEDs : Display current status and
error.
Battery Socket : Keeping Date and Time.
Reset S/W : For rebooting Data Saving
Module.
SD Card Slot : For installing the SD card.
• SD Memory Card.
- Use 2GB ~ 8GB SD or SDHC
- FAT32 format should be preceded before in
use.
- Maximum file size per a day :
Approximately 150MBytes
- Output file format : S(model
name)(year)(month)(day).csv
ex) Multi-V IV, 2013(year) 7(month)
15(day) ' S4130715.CSV
• Battery – Use CR2032
Yellow
Green
8
7
Red
5
6
Power LED
RX LED
TX LED
!
NOTE
• Remove the SD card after turning off
the start switch.
• When Data Saving Module lost power,
battery have to set on battery socket for
Keeping Date and Time.
• SD card may lose data when using
more than one month. It is recommend-
ed to use within one month.
LED State
• Green LED
: Display current state.
- On recording : Blinking in 5 seconds interval.
- When SD memory card is initially inserted
or memory capacity calculation is operated
at every minutes : ON for several
minutes(seconds) ' OFF.
• Yellow LED
: Display start of data recording
- Start SW On : always ON
- Start SW Off : always OFF
• Red LED
: Display normal or error state.
- Normal state : Blinking in 1 sec interval.
- Error state : LED OFF for 2 seconds '
Blinking current error as bellows.
7 times : Memory card Lock
8 times : No memory card
Advertisement
Table of Contents
