Table of Contents
Advertisement
7. Multiple screens installation
(1) When installing the displays in a multiple screens configuration, turn the displays off and leave a gap of 1.0 mm
between each display.
Note that light from the back may pass through the gaps between the displays.
To prevent the light from passing through the gaps, install a plate that stops the light at the back of the displays.
This plate is not supplied by NEC.
(2) Consider the following when installing the display in a multiple screens configuration.
(a) Check that the wall to which the mounting brackets will be installed is perfectly flat.
(b) Make sure that the mounting brackets used are strong enough to meet the installation requirements.
(c) Choose a structure in which load is not applied on the display top and left sides.
(d) Pay attention that the cable route does not interfere with other parts of the structure.
(e) Choose a configuration with which there is no risk that the displays bend after they have been installed.
English - 14
Gap of 1 mm
Advertisement
Table of Contents
