Advertisement
Quick Links
Auto-Tilt Chassis
RT1200 Traction Unit
Model No. 25511
Model No. 25511E
This product contains a chemical or chemicals known to the State of California to
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Tilt sensor
Bolt
Locknut
Rocker switch
No parts required
Installing the Auto-tilt Chassis
1. Remove the four bolts securing the foot plate to the
frame and remove the plate (Figure 1).
1. Foot plate
2. Disconnect the wire harness from the foot-pedal
sensor and set the floor plate aside.
3. Install the tilt sensor under the floor under the seat
using 2 bolts and locknuts (Figure 2).
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Figure 1
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
1
2
Install the auto-tilt chassis.
2
1
–
Calibrate the sensor.
1. Tilt sensor
4. Connect the sensor to the open connector from the
main wire harness as shown in Figure 3.
Form No. 3383-980 Rev A
Installation Instructions
Use
Figure 2
2. Bolts
Original Instructions (EN)
All Rights Reserved *3383-980* A
Printed in the USA
Advertisement
Summary of Contents for Toro 25511
- Page 1 Form No. 3383-980 Rev A Auto-Tilt Chassis RT1200 Traction Unit Model No. 25511 Model No. 25511E Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Figure 3 (Floor removed for illustrative purposes) 1. Tilt sensor 2. Wiring-harness connector 5. Connect the wire harness you disconnected in step 2 to the foot-pedal sensor. Figure 5 6. Install the foot plate, securing it with the 4 bolts Home Screen removed previously, and connect the foot pedal to the drive linkage.
- Page 3 8. Use the toggle switch to return the machine to the level position. 9. Press button 2 to select Set Center (Figure 8) and wait unit the center indicator light turns green (approximately 10 seconds). 10. Use the toggle switch to tilt the machine to the full right position.