Table of Contents
Advertisement
How to Attach Options to the Plasma Monitor
You can attach your optional mounts or stand to the plasma moni-
tor in one of the following two ways:
In the upright position.
Lay the screen face down.
Lay the protective sheet, which was wrapped around the monitor
when it was packaged, beneath the screen surface so as not to
scratch the screen face.
This device cannot be used or installed without a separate
Tabletop Stand or other optional mounting accessory. For
proper installation it is strongly recommended to use a
trained, NEC authorized service person. Failure to follow
correct mounting procedures could result in damage to the
equipment or injury to the user or installer. Product war-
ranty does not cover damage caused by improper installa-
tion. Failure to follow these recommendations could re-
sult in voiding your warranty.
8
P
M
LASMA
ONITOR
†
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding ob-
jects as shown in the diagram to the right.
50mm (1.97")
31mm (1.22")
50mm (1.97")
Pulling Out and Reinserting the Retractable Feet
Notice:
See "Extending the Simple Feet" on page 49.
* Installation of only the main unit is not possible. Be sure to use
and install the main unit in conjunction with a stand or special
unit.
NOTE: RETRACTABLE FEET ARE FOR TEMPORARY USE ONLY AND ARE
NOT INTENDED FOR PERMANENT INSTALLATION.
MODEL # PX-42VPU1-ST STAND IS REQUIRED FOR PERMANENT TABLE-
TOP INSTALLATION.
REPLACE THE FEET WHEN YOU MOVE THE MONITOR.
31mm (1.22")
45mm
(1.77")
Advertisement
Chapters
Table of Contents
Troubleshooting
