LG LS091HSV3 Installation Manual page 22
Single zone high efficiency, standard, extended pipe, and mega wall mounted
Hide thumbs
Also See for LS091HSV3:
- Owner's manual (102 pages) ,
- Installation manual (86 pages) ,
- Engineering manual (76 pages)
Table of Contents
Advertisement
GENERAL INSTALLATION GUIDELINES
Mounting of Indoor Unit Installation Plate
Mounting Installation Plate to Wall (240HSV3, HV3, HLV)
Follow the procedure and best practices when mounting the indoor
unit's plate to a wall.
Procedure
1. Mount the installation plate horizontally by aligning the centerline
using a leveling tool (Figure 13).
2. Use type "A" screws when mounting the plating (these screws
come with the plate).
• If mounting the unit on concrete wall, use field supplied anchor
bolts.
3. Observe the left and right rear piping clearance when drilling into
the wall, as shown in Figure 14.
Select location carefully. Unit should be anchored to a strong wall to pre-
vent unnecessary vibration.
• When choosing a location for the wall mount plate, be sure to take
into consideration routing of wiring for power outlets within the wall.
Contacting wiring can cause serious bodily injury, or death.
• Use caution when drilling holes through the walls for the purposes
of piping connections. Power wiring can cause serious bodily injury,
or death.
Drilling Piping Hole in the Wall
Follow the left or right piping clearance recommendations.
ø
1. Using a 2-5/8 (
65mm) inch hole core drill bit, drill a hole at
either the right or left side of the wall mounting (Figure 15).
• The slant of the hole should be 3/16" to 5/16" from level with the
slant being upward on the indoor unit side and downward on the
outdoor unit side.
2. Finish off the newly drilled hole as shown with bushing and
sleeve covering.
• Sleeve and bushing prevents damage to the tubing/bundling of the
piping.
See Refrigerant Piping Connections for Indoor Unit on
page 43 to proceed with piping.
22
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 13: Installation Plate - Mounting
Installation Plate
Chassis
Hook
Type "A" Screws
Figure 14: Installation Plate - Mounting
Installation Plate
30-
11/16
1-11/16
4-11/16
Unit: Inch
Left rear piping
Figure 15: Drilling Piping Hole
Indoor
Core Drill
Bushing
Sleev e
13-
1-11/16
4-11/32
Right rear piping
WALL
Outdoor
3/16
Hide quick links:
Advertisement
Table of Contents
