NEC MultiSync LCD1525M LCD1525M LCD1525M User Manual page 15
Nec lcd monitor user's manual
Hide thumbs
Also See for NEC MultiSync LCD1525M LCD1525M LCD1525M:
- User manual (40 pages) ,
- Setup instructions (2 pages) ,
- Dimensional drawing (1 page)
Table of Contents
Advertisement
Available languages
Available languages
Tools 2
Language: OSM controls menus are available in six languages.
OSM Position: You can choose where you would like the OSM controls
menu to appear on your screen. Selecting OSM Position allows you to
manually adjust the OSM controls menu position from among Center,
Top left, Top right, Bottom left and Bottom right.
OSM Turn Off: The OSM controls menu will stay on as long as it is in
use. In the OSM Turn Off sub-menu, you can select how long the
monitor waits after the last touch of a button for the OSM controls menu
to disappear. The preset choices are 10, 20, 30, 45, 60 and 120
seconds.
OSM Lock Out: This control completely locks out access to all OSM
controls functions except Brightness and Contrast. When attempting to
activate OSM controls while in the lock out mode, a screen will appear
indicating that OSM controls are locked out. To activate the OSM Lock
Out function, press PROCEED, then press L and hold down
simultaneously. To deactivate the OSM Lock Out, press PROCEED,
then press L and hold down simultaneously.
IPM System Off Mode:
Enable:
The IPM System works normally and all stages of energy
savings are utilized.
Disable:
The Off Mode of the IPM System is not used.
NOTE:
For standard systems and graphics boards, keep the factory
setting at ENABLE.
EdgeLock Control: Operating your monitor at a non-standard timing
may cause images to appear darker than normal or have color
distortion. Use of the EdgeLock control will adjust images to their normal
state.
Information
Display Mode: Indicates the current mode and frequency setting of the
monitor.
Monitor Info: Indicates the model and serial numbers of your monitor.
Refresh Notifier: A message will advise you if the refresh rate of the
signal being applied to the monitor by the computer is too low. For
further information, please refer to your display card or system manual.
English-7
Hide quick links:
Advertisement
Table of Contents
