Table of Contents
Advertisement
How to Attach Options to the Plasma Monitor
You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
* In the upright position. (See Drawing A)
* Lay the screen face down (See Drawing B). Lay the
protective sheet, which was wrapped around the monitor
when it was packaged, beneath the screen surface so as
not to scratch the screen face.
• This device cannot be installed on its own.
Be sure to use a stand or optional mounting
unit. (Wall mount unit, Stand, etc)
* See page 2.
• For correct installation and mounting it is
strongly recommended to use a
trained,authorized NEC dealer.
Failure to follow correct mounting proce-
dures could result in damage to the equip-
ment or injury to the installer.
Product warranty does not cover damage
caused by improper installation.
Ventilation Requirements for
enclosure mounting
To allow heat to disperse, leave space between
surrounding objects as shown on the diagram be-
low when installing.
Pulling Out and Reinserting the
Retractable Stand
Retractable Stand are housed at 2 locations on the bottom
surface of the main unit.
1. Grasp the end and pull out.
2. The stand will open automatically when your hand is
removed.
To house the Retractable Stand, close them and then con-
tinue to push them inside the main unit.
Notice:
* Installation of only the main unit is not possible. Be sure
to use and install the main unit in conjunction with a
stand or special unit.
Note:
RETRACTABLE FEET ARE FOR TEMPORARY USE
ONLY AND ARE NOT INTENDED FOR PERMA-
NENT INSTALLATION.
MODEL # PX-42VPU1-ST STAND IS REQUIRED
FOR PERMANENT TABLETOP INSTALLATION.
REPLACE THE FEET WHEN YOU MOVE THE
MONITOR.
Drawing A
Drawing B
31
mm
(1.22")
1
8
50
(1.97")
mm
31
mm
(1.22")
50
(1.97")
mm
45
(1.77")
mm
2
Wall
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
